Advertising engraving machine tips and dust removal?

1, advertising engraving machine skills:

(1) Engraving tool selection, pay attention to the influence of the cutting edge angle and blade width on the machining accuracy and progress. If the cutting edge angle and the blade width are large, the machining speed is fast, but the machining pattern is not fine, the cutting edge angle and the cutting edge The width is small, the processing speed is slow, but the graphics are fine and the durability of the tool is relatively poor.

(2) In the actual processing, the relationship between the machining effect and the machining efficiency should be fully considered, and the coarse knife, the fine knife and the three-dimensional sculpture can be flexibly applied, and the large-area graphic area engraving is processed by using a large cutter, and the small-area graphic area or To reflect the effect, a small tool should be used for fine machining, and the setting of the overlap rate of the tool is also important.

(3) According to the requirements of processing effect, the path generation method is selected. The two-dimensional path is suitable for plane engraving. The processing effect does not have a strong three-dimensional effect, and the processing fineness is inversely proportional to the processing depth. The three-dimensional path has a "clear angle" engraving action, the processing effect has a strong three-dimensional effect, the processing pattern is fine, the processing fineness is directly related to the fineness of the pattern and the accuracy of the tool parameters, and the processing depth only affects the three-dimensional and does not affect the fineness of the processing. The degree, the greater the processing depth, the stronger the stereoscopic effect.

(4) Select the processing method according to the processing result requirements-----two-dimensional engraving, three-dimensional engraving or cutting. If pattern engraving is performed, two-dimensional or three-dimensional engraving is selected, and the generated processing path is the engraving path. If you are cutting and machining the wall surface of the sand table model, select "Cutting Word" and the generated path is the cutting path.

(5) According to the fineness of processing and the texture of the material, the engraving processing path form----horizontal milling bottom, longitudinal milling bottom, forward 45 degree milling bottom, reverse 45 degree milling bottom, the machining precision generated by these engraving paths is high. The processing surface is smooth. The circular path has a fast processing speed and high efficiency, but the processing effect is inferior to others.

2, advertising engraving machine dust removal: advertising engraving machine dust removal method is as follows

(1) Use a brush to remove dust from the table.

(2) Open the end caps on both sides of the machine and clean the guide rails of the engraving machine: Move the beam to the inside. Locate the guide rails as shown above, wipe the place where the guide rails on both sides are in contact with the rollers with a dry cotton cloth, and then move the beam to clean the remaining areas.

How to prevent dust before the advertising engraving machine removes dust?

A dust removal device can be purchased or installed.

What are the requirements for the use of bad environment in advertising engraving machines?

1. Avoid equipment such as strong electricity and strong magnetism that seriously affect the signal transmission of the engraving machine.

2. Use a three-core power supply to ensure good grounding of the engraving machine and reduce interference.

3, the voltage requirements are stable, to avoid large fluctuations, it is best to use a voltage regulator.

4. The machine should not work for a long time in a strong acid or alkali environment.