Three ways to improve the efficiency of woodworking engraving machine

  1. For the friend of our woodworking engraving machine, the most important point is to determine a reasonable cutting amount according to the hardness of the engraving material and the performance of the stone engraving tool, which is the depth of each layer that we usually say.
 2. We can also carry out roughing and then finish machining according to the actual situation. When roughing, remove all the remaining amount as much as possible to save the finishing time; also use the tool material with better processing performance. The performance of the stone engraving machine is not only reflected in the hardware configuration of the machine, but also requires us to accumulate processing experience little by little to improve the processing efficiency.
3, each material of the tool will have a maximum amount of knife, when we use woodworking engraving machine processing, try not to use the maximum tool amount of the tool for processing, long time processing, the tool damage is faster. Moreover, the speed is not improved when the maximum amount of knife is processed, and the speed is likely to cause the knife to be broken.
      Therefore, it is better to set the amount of the lower knife to 2/3 of the maximum amount, so that the tool life will be greatly increased, and the processing speed can be improved a lot; thus, the tool cost can be saved and the processing efficiency can be improved.